Create Join, but GC port 3268 not available

By default, when BOTH option is enabled on sync to an LDAP destination, the destination DC is expected to be a GC. The Join function utilizes 3268 (even though the DC port is used for writing (389/636).

If you can only point to a DC (not GC) or If you do not have access to port 3268, you can override the default to allow you to JOIN on 389.

Go to to the Custom tab, click Raw Config. Enter this line:

join-use-gc=no

Click Save. Click Save.

When you run Simulation or sync, port 389 (or 636) is used instead.